×

We'll help you find the right contractor.

Share your project details and we'll reach out to Adrian Plumbing and Electric Inc so you don't have to.

We'll also connect you with other vetted professionals who are a strong match for your project. That way, you can compare quotes, meet different contractors, and make the choice that feels right for you.

Get Started
Is this your business? Claim now >
A

Location and Projects

Address
PO Box 159, Adrian, MN, 56110
Use our bidding system to request a quote

Adrian Plumbing and Electric Inc

Adrian Plumbing and Electric Inc, Adrian, Po Box 159, Adrian, MN (Owned by: Wesly William Henriksen, Rosem) holds a Plumbing license and 6 other licenses according to the Minnesota license board.

Their BuildZoom score of 106 ranks in the top 7% of 77,973 Minnesota licensed contractors.

Their license was verified as active when we last checked. If you are thinking of hiring Adrian Plumbing and Electric Inc, we recommend double-checking their license status with the license board and using our project planner to get competitive quotes.

Adrian Plumbing and Electric Inc Contact Information

Phone: (507) 483-2152 Edit
Address: PO Box 159, Adrian, MN 56110 Edit

Building Permits by Adrian Plumbing and Electric Inc

Sort by: Notable Notable | Date Date | Job Value Job Value
Electrical permit
2025-06-26
A new 400 amp service was installed inside the building just north of the grain bins. wire was trenched from the new service over to a 400 amp terminal box on the bin next to the dryer. feeders were then tapped off of the terminal box to go to the dryer and blower system
Valuation:
N/A
Permit #:
ELE2410-00912
Status:
final
Fee:
$57
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2025-05-01
There was a building in this location previously that had a 3-wire feeder going to it so that existing 3-wire feeder was used to supply power to the new building. typical shop wiring: lighting door openers receptacles compressor boiler and water heater
Valuation:
N/A
Permit #:
ELE2505-00065
Status:
final
Fee:
$156
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2025-06-10
Old shop burned down last year. new shop was built over the winter. there is an existing terminal box that fed the previous shop. we will be powering this shop off of that existing terminal box. other than that this is a standard farm shop with new wiring for lighting receptacles door openers etc
Valuation:
N/A
Permit #:
ELE2505-00303
Status:
final
Fee:
$126
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2025-02-06
Addition includes a living room office and laundry on the main floor. the addition also includes a couple of bedrooms upstairs. there will also be some rewiring done in the existing adjacent rooms
Valuation:
N/A
Permit #:
ELE2407-12839
Status:
final
Fee:
$71
Permit Type:
One-family dwelling
Building Type:
N/A
Electrical permit
2025-06-05
New feeders will be trenched underground from the yard pole east of the house across the driveway to a white farm building north of the yard pole. these feeders terminate in a 100 amp disconnect in the building
Valuation:
N/A
Permit #:
ELE2506-01118
Status:
final
Fee:
$42
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2025-04-03
3 baseboard heaters were added in the hallways of the adrian government center. a sub-panel was added in order to have enough breakers spaces for these heaters
Valuation:
N/A
Permit #:
ELE2503-12917
Status:
final
Fee:
$54
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2025-01-02
Bedroom added onto existing house. wiring for lights outside lights & receptacles to be installed in this addition. some wiring extended into existing living room
Valuation:
N/A
Permit #:
ELE2409-08310
Status:
final
Fee:
$71
Permit Type:
One-family dwelling
Building Type:
N/A
Electrical permit
2024-06-06
Power was trenched to a small shop/shed in order to install a 100 amp panel and branch circuit wiring within the building. auxillary power was also trenched to the building in order to mount a generator inlet and establish a place to plug in a backup generator for the site
Valuation:
N/A
Permit #:
ELE2405-09549
Status:
final
Fee:
$101
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2025-03-27
Old 100 amp fuse panel removed and replaced with 100 amp circuit breaker panel. disconnecting means was installed on the outside of the house
Valuation:
N/A
Permit #:
ELE2412-05929
Status:
final
Fee:
$76
Permit Type:
One-family dwelling
Building Type:
N/A
Electrical permit
2024-12-19
Grounded receptacles were installed throughout the house but due to no equipment ground being available throughout most of the house gfci protection was installed in all of these locations either through a gfi breaker or gfi receptacle
Valuation:
N/A
Permit #:
ELE2412-05904
Status:
final
Fee:
$36
Permit Type:
One-family dwelling
Building Type:
N/A
Electrical permit
2025-07-31
Adding a 200 amp panel in this farm shop which will also refeed the existing 100 amp panel. branch circuit wiring will also be added for lights receptacles and equipment
Valuation:
N/A
Permit #:
ELE2502-06550
Status:
final
Fee:
$72
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2025-06-26
100 amp feeders will be run to this building to provide branch circuit wiring for lights receptacles and door openers
Valuation:
N/A
Permit #:
ELE2506-05393
Status:
final
Fee:
$72
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2024-10-31
Bedroom addition to existing house. there are just two circuits being added one for lights and receptacles and one for baseboard heat. sub-panel being added in the basement to accommodate these two circuits
Valuation:
N/A
Permit #:
ELE2409-00753
Status:
final
Fee:
$71
Permit Type:
One-family dwelling
Building Type:
N/A
Electrical permit
2024-08-01
New panel installed which is fed by an existing 3-wire feeder. all branch circuit wiring redone within the barn loadout and attached hallway. there are a few barns on the site. this one is the northwest barn
Valuation:
N/A
Permit #:
ELE2407-12830
Status:
final
Fee:
$90
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2023-07-10
Added a 400 amp service to the existing 600 amp service in order to handle the load for the new corn dryer new blower system and existing bins. wiring was installed for the corn dryer for load and unload motors associated with the dryer and also for the new blower motor. a panel was also installed in the shed next to the dryer where existing branch circuit wiring was re-fed
Valuation:
N/A
Permit #:
ELE2307-01547
Status:
final
Fee:
$156
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2025-01-02
Shop and office building burnt down in november 2023. new shop and office building to be built. 400 amp feeders are already ran down to this structure. 400 amp disconnect will be mounted on the outside of the building. feeders will be ran to at least 3 different panels within the building. branch circuits will be ran from these panels
Valuation:
N/A
Permit #:
ELE2312-07300
Status:
final
Fee:
$346
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2024-09-19
New single phase 600 amp service to be installed. 200 amp feeders to be ran to existing corn dryer. 225 amp feeders to be ran to blower system inside dryer shed. 80 amp feeders ran to branch circuit panel inside dryer shed. branch circuit wiring for: blower motor air lock unload motor wet corn incline auger motor lights and receptacles in dryer shed
Valuation:
N/A
Permit #:
ELE2312-07295
Status:
final
Fee:
$190
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2024-09-13
New 3-phase 120/208 800 amp service to be installed. automatic transfer switch and generator will also be included in this installation. new 600 amp feeders were ran from new service to grain receiving shed. feeders also redone from main service to yard pole 400 amp disconnect
Valuation:
N/A
Permit #:
ELE2312-07245
Status:
final
Fee:
$314
Permit Type:
Non-dwelling
Building Type:
N/A
Electrical permit
2023-08-25
Added 3 receptacles in the laundry room added receptacles in basement office added kitchen countertop receptacle in kitchen (south of sink) added undercabinet lights in kitchen installed exhaust fans in main floor bathroom and basement bathroom and replaced 12 space interior with a 16 space interior in sub-panel in basement
Valuation:
N/A
Permit #:
ELE2308-06030
Status:
final
Fee:
$36
Permit Type:
One-family dwelling
Building Type:
N/A
Electrical permit
2023-06-20
Three motors were wired in order to transport a new ingredient into their feed mill system. the unloader or agitator motor is a 3-phase motor that is ran through a vfd and controlled by their plc system in the feed mill. the incline motor and auger into mixer motors are both single phase motors that are controlled through their plc system as well. a sub-panel was also installed to cre... see more
Valuation:
N/A
Permit #:
ELE2306-06062
Status:
final
Fee:
$37
Permit Type:
Non-dwelling
Building Type:
N/A

Similar Contractors See more

License # L3836
95
BZ Score
-
Avg Project
-
Projects
License # HC738265
99
BZ Score
-
Avg Project
-
Projects
License # L1716
93
BZ Score
-
Avg Project
-
Projects

Adrian Plumbing and Electric Inc Reviews

BuildZoom hasn't received any reviews for Adrian Plumbing and Electric Inc. Click here to be alerted when reviews are posted about them.
Please write a review about Adrian Plumbing and Electric Inc
1 Rate this plumber
Click stars to rate
2 Provide a detailed review of this plumber.