Share your project details and we'll reach out to
Farrell Heating and Cooling LLC
so you don't have to.
We'll also connect you with other vetted professionals who are a strong match for your project. That way, you can compare quotes, meet different contractors, and make the choice that feels right for you.
Their BuildZoom score of 100 ranks in the top 13% of 12,093 Connecticut licensed contractors.
Their license was verified as active when we last checked. If you are thinking of hiring Farrell Heating and Cooling LLC, we recommend double-checking their license status with the license board and using our bidding system to get competitive quotes.
I would be installing (2) 60 000 btu bosch high efficiency 96% natural gas furnaces model bgh96 multi zone systems for first and second floors with bosch split system heat pumps model ids bovaa15.these systems will have sheet metal supply and return plenums with sheet metal supply trunk lines with foil flex run outs and return runs.both systems 2” pvc intake and exhaust with bay vent ... see more
Installation of 8” fresh air makeup with automatic damper to bring fresh air into kitchen area to work off an air pressure switch installed in new kitchen exhaust hood. this work will also include the ducting of 8” exhaust hood and sidewall wall cap termination location to be determined
Installation of a 14 seer 36, 000 btu split air-conditioning system.broan 14 seer air handler in the basement standing vertical on the floor with sheet metal base and sheet metal supply and return plenums with both sheet metal rectangular ductwork and round duct with foil flex run outs to sheet metal floor boots. all supply and return registers installed in the floor. system will have... see more
The installation of a airtemp 23 seer single zone ductless mini split heat pump in all season room. i would be installing a high wall mounted ductless head on interior storage room wall approximately 12’ of refrigeration line set and drain to outdoor condenser which would be set back corner of garage and would be set on a prefab pad and snow leg risers to stay about expected snow levels
Installation of airtemp ghh18luk 40h gxh18l5k 40h ductless heat pump single zone system. high wall mounted indoor unit in 3 season room with outdoor unit set on prefab pad with snow less and all lines covered with pvc line hide
Installation of lp up flow forced hot air furnace 95% condensing gas 2” pvc vented with 2” intake air with 14 seer split ac.furnace will be in basement furnace room and have 2 zones basement zone and 1st floor zone.i will have a sheet metal riser supply and return throughout 1st floor closet chase to attic and will be running round metal supply trunk wit 6”& 7” take offs to each room... see more
Installing (2) air temp gx436fmk40h multi zone mini split heat pump out doors on stands sitting on poly pre fab pads with (4) 18, 000 indoor wall mounted ductless units. all lines covered with white lineset (slim duct) with surge protected disconnect boxes. knight hall school and childcare center
Repipe natural gas piping from basement to new gas meter locations outside of house. new meter bank has been installed by gas company.connect new piping in basement to existing alliances. approximately 60 feet of piping
Fresh air 6 make up for new kitchen exhause hood adding floor register connected to damper to outside intake louver for fresh air to kitchen space. also relocating existing 2 air conditioning supply registers in floor - existing modifications
Installation of new gas piping from (3) meters to (3) navien ncb-240e 18000 to 120, 000 btu condensing tankless water heater & boiler; installing (3) one for each floor direct vent out to south side of building and gas piping from meters to each unit to domestic hw (baseboard not included)
Installation of fujitsu ductless mini split heat pumps. (1) aou36rlxf21 multi zone system with (3) heads and (1) aou24rlxf2 multi zone with (2) heads. all wall-mounted ductless heads outdoor units on poly pads with snow legs and risers off the ground
Installation of fujitsu ductless mini split heat pumps. (1) aou36rlxf21 multi zone system with (3) heads and (1) aou24rlxf2 multi zone with (2) heads. all wall-mounted ductless heads outdoor units on poly pads with snow legs and risers off the ground
Adding fresh air intake to make up air from new exhaust hood over 400 cfm. bringing air into hvac system. moving two wall supplys in kitchen remodel. toe kicks under new cabinets. relocating return from kitchen wall to closet up to second floor
Ductwork rough only. moving some existing wall stack. adding (2) new run 7 150 cfm per run to addition. (1) on 1st floor and (1) above on 2nd floor. extending return up to 2nd floor from existing ductwork. most runs are duct modifications
Oil to gas conversion. installation of wall mounted condensing combi boiler ngr pvc intake exhaust and remove old oil boiler and oil tank. running 1 black pipe for natural gas
Oil to gas conversion. installation of navien 240r combi boiler with 2 pvc intake and exhaust with rigid black steel gas piping. removing old oil tank fill and vent boiler and flue pipe. capping off flue with cap and cover
Oil to gas conversion. > replacing oil fired boiler with navien on-demand combi wall hung boiler with all new gas piping rigid & megrpress pvc intake & exhaust direct vent
Installation of new gas piping from (3) meters to (3) navien ncb-240e 18000 to 120, 000 btu condensing tankless water heater & boiler; installing (3) one for each floor direct vent out to south side of building and gas piping from meters to each unit to domestic hw (baseboard not included)
BuildZoom verified this license was active as of July 2026.
Verify this license's status for Farrell Heating and Cooling LLC at the Connecticut Department of Consumer Protection.
This is a sample of licensing data; click here to access a complete history.
Inactive License
License #
NAT-F151377-1
Status
Inactive
Nation
Environmental Protection Agency
Type
Renovation
According to the United States Environmental Protection Agency, the status of this license was at one point cancelled. However, this information may have changed. If this is your business, please update your license status.
Check this license's status for Farrell Heating and Cooling LLC at the United States Environmental Protection Agency.
This is a sample of licensing data; click here to access a complete history.