Perry Plumbing & Heating at 21 Autumn Pond Park, Greenland, NH 03840, held a HVAC/Mechanical Contractor license (#MBE0002464) with the New Hampshire contractors license board with an expiration date of 01-31-2022. We last verified the license was expired on 09-20-2022.
Their BuildZoom score is 0 because we haven’t been able to verify an active license. As a result, they’re not ranked in the top 50% of 13,069 New Hampshire contractors.
If you’re thinking about hiring them, we recommend double-checking their license status with your local licensing authority. Alternatively, use our bidding system to be easily matched to qualified, licensed professionals in your area.
We will install a black iron gas main that will serve (1) generator (1) fireplace and (1) modine unit heater in the detached greenhouse. we will use underground poly pipe risers to get extend out to generator and greenhouse
We will install a black iron manifold at the gas meter (which will be located in an outdoor mechanical area near the driveway entrance). the manifold will serve an outdoor grill located on the back covered porch a generator and a future stub up at the house outside the mechanical room for any future interior gas needs. these lines will all have indicidial shutoffs at the meter manifol... see more
We will be remodeling the existing third floor bathroom to include a toilet double lav shower free standing tub and steam generator. the tub and shower will be located in a common wet room that will have a floor drain serving the showering area and another floor drain serving the tub
- kitchen sink replacement at existing location. dishwasher hookup and relocated ice maker.- fully remodeled first floor master bathroom with fixtures moving location. the lav sinks in this bathroom may require an aav due to possible beam separating the existing vent from their new location and finished space above. tbd in field.- fixture replacements only at existing locations at sec... see more
We will be utilizing an existing 3/4 capped stub at the gas meter and running a new 3/4 gas line to a cooktop located in the addition. we will likely use a combination of black iron and wardflex as some of this piping will travelk outdoors for +/- 25 before entering into the building
We will be installing a new black iron gas manifold (2 size) to serve (1) boiler (1) cooktop and (6) fireplaces. see attached sheet for details. this will be fed from the existing gas meter located on the front left corner of the mansion
We will perform a full rough in and finish placement of fixture quantities as shown on the floor plans. the lower level bathroom will be served by a liberty pro 380 ejector. an 80 gallon electric water heater will be installed
We will provide all rough in and finish materials and labor for a completed installation of the fixtures and appliances as shown on the floor plans. we will install (2) heat pump style water heaters
We will be swapping fixtures and appliances at existing locations for one kitchen located on the first floor and one kitchen located on the second floor. each kitchen will have a sink dishwasher and ice maker water line
We will be adding a new powder room on the first floor. the kitchen gets a full remodel with relocated sink dishwasher and ice maker line. we will be roughing in provisions for a future bar sink at this time as well
We will be adding all new services to a half bathroom and clothes washing machine located in the addition. the kitchen gets a remodel with the sink shifting +/- 5 along the outside wall. due to large timber framing an aav is requested for the kitchen sink line. a new electric water heater will be installed
We will be adding all new services to a second floor bathroom located above the entryway. due to finished third floor space above i am proposing an aav to vent the bathroom group. we will make connections to the existing hot cold drainage in the unfinished basement
We will be adding a new gas line in the back yard to serve a fire pit. we will tie into the existing black iron piping in the pool house and extend out the back right corner. from there we will run underground with poly pipe and risers to the fire pit location
We will install a sub slab ejector tank to serve a laundry service laundry sink one half bathroom one full bathroom and a kitchen sink 1- bar sink as shown on the attached floor plans. the mechanical room that will serve the building is also outlined in the lower-level floor plan
New systems for a kitchen sink dishwasher and refrigerator ice & water feater. new outdoor faucet. the 2 x 6 outside wall framing will be used for concealing the 1-1/2 size drain vent piping or the outside wall use will not be required if an air admittance valve is approved for use with 2 drain size. please advise on your preference?
Kitchen sink replacement at existing island location (mechanical venting device requested here) first floor bathroom remodel master bathroom remodel hall bathroom remodel new third floor half bathroom new laundry room clothes washer sink
Installation of fixtures and appliances as shown on the floor plans including an 80 gallon hybrid water heater. a sink and floor drain will be added in the greenhouse and served by an emt 2.5 point of use electric water heater
We will install a dedicated water line for irrigation which is intended to have its own irrigation meter. the 1 line will be protected by a watts 007 double check valve assembly located in the water service room and extend +/- 30 through dropped ceiling where it will extend outdoors for continuation by irrigation contractor
We will be taking over for the continued rough in of water lines venting and a small amount of drain work to addition a sink in the break room. an 1 1/2 pvc drain is currently extending up out of the floor. we will continue it into the sink cabinet and extend venting up to an existing vent line running paralell down the hallway outside of the break room. cold water will generate from ... see more
We will be roughing in underslab drainage for a basement bathroom as well as (2) floor drains (that will be combination waste and vent) to serve the sauna and steam room. these drains will be served by a liberty pro-380 ejector tank
According to the New Hampshire Joint Board, the status of this license was at one point cancelled. However, this information may have changed. If this is your business, please update your license status.
Check this license's status for Perry Plumbing & Heating at the New Hampshire Joint Board.
This is a sample of licensing data; click here to access a complete history.