Install new circuits for range fridge and dining outlets. install 2x new circuits for kitchen outlets. relocate dishwasher wiring. install under-cabinet lighting at 2x locations. addition light fixture in kitchen entryway. addition 3x sconces in kitchen with 2x 3-way switch systems. replace main floor switches with customer-provided replacements. install plug-mold for 2x outlets and 1... see more

2 200a services and 3 bc for install 60-amp feeder and sub panel at barn. install 60-amp feeder and sub panel at sauna location. wire up heater and light kit. land water heater circuit in shop panel. 2 feeders +3 circuits

1 200-amp service upgrade 5 bc for combine 3x panels into 1 remove wiring for heaters from panel gfci protect ungrounded ckts install 3-prong in place of 2-prong remove and safe off unprotected nmb in upstairs area

Building service outlets x2 pole lights x2. 12/03/2024 update: used to be an old house on the lot w a service. took that existing service and mounted it to a pole for future use. work done in the field/empty lot

Full permit to replace minor label #els1048554 - inspector came to inspect the minor label & discovered that the contractor (terrafirma foundation systems) had relocated wiring to install a window. this alteration occured after sump pump wiiring was completed by bear electric. new permit required per inspector to clean up wiring & re-inspect

(1) 200 amp service & 5 bc's for air conditioning electric furnace gfci sub panel condensate plug. 1 serv+ 5 circuits

Existing hot tub circuit was split to supply power for irrigation pump. if necessary we will need to pull in #6 thhn and set an outdoor rated sub panel. from sub we will refeed 20a/240v pump circuit 20a/120v boathouse and 50a/240 hot tub. underground run approx 40 total run 70

Existing circuit. need to set disconnect and run load side to hot tub. this run will be under or around deck. about 13’ from disconnect to tub. install 50-amp sie gfci breaker (ordered on 10/05). existing is a 60. make existing service outlet code

Take out electric heat breakers-5 of them for new. 2-30 amp service outlet air handler. 5 circuits

Two electric furnace circuits one heat pump circuit and one service outlet circuit. 4 circuits

Install 2x 20amp underground circuits to detached garage. wire interior light switch outlet. install ceiling outlet for garage door opener

240 volt welder circuit air compressor circuit 2 120 volt/20 amp circuits receptacle in laundry 5 garage lighting outlets replace lights in kitchen christmas receptacle

100 amp feeder to a new sub panel at garage. refeed ev charging circuit into new sub panel. wire new mini-split system in garage

Heat pump circuit service outlet breaker change for air handler from 125a to 90amp

(1) 200 amp panel 60 bc's and limited energy for installation of transformer and electrical panel along with branch wiring for 2 office spaces inside of main building

Adding 4 circuits for kitchen and bathroom update and garage lights and plugs

Reconnect/relocate heat pump new heat pump reconnect electric furnace new electric furnace service outlet (therapeutic associates newberg physical therapy)

Run 50-amp (#6 cu) to hot tub location. homline panel. take 50-amp gfci breaker. conduit will be run along curb of patio

60a feeder sub panel (in existing underground conduit - to be done by others). switch w/motion sensor 8 receptacles 4 customer provided lights

Replace metermain new feeder to house and generator installation