Some wall studs were accidentally damaged during demo of our remodel project. Our contractor says that the studs can be repaired by nailing new studs to the damaged ones instead of pulling them out completely and replacing them. Is this safe?
Yes, this is safe. As long as the new stud is mechanically fastened to the original stud, the top plate, and the bottom plate, you will be fine.
The term is called “sistering” or scabing.
And yes, it’s safe
It depends on the severity of the damage but it is possible to repair the studs nailing 2 studs on each side of the stud. Of course the safest way is to replace the whole thing. But itll be fine if the damage isnt major.
Yes it is safe to scab a new stud in the place of the damaged one but you need to make sure your contractor did not damage more
Depends on if studs are load bearing or free studs. If contractor replaces stud from sill to top plate and not just a piece it should be fine structurally. Depending on your inspection department, it could be frowned upon or even fail inspection.
If the stud is just cracked, but still whole, the fix is simple. Drywall for residential homes is usually 5/8 inch thick. Screw as many 1 to 1 1/2 inch wood screws through the sheet rock and into the stud.Again cut out how much drywall you need to do the job. Expose both sides of the break. Take a length of 2x4 about 24 inches screw it into the stud above the break.Screw the bottom of your board into the lower section of the stud. Patch the drywall as needed…
1 Like